The first step would be to first find the correct kind of interfacing that will work for you form of interfacing fabric. Mostly these instructions will be on the back of the pattern envelope that you bought. If you are creating your own patterns at home, it could be wise to first test what interfacing will continue to work on the type of fabric you might be using. You just need a small component of fabric and measure a block, fuse the piece and measure it again to see precisely what the different shrinkage was.
Now to me which is doing sewing at home and as a hobby I don’t use a fusing press or fusing machine similar to most clothing manufactures have. I still have to use to old reliable way in which worked for me.
The various tools that you simply would require is definitely the following:
3. Correct interfacing
I realize other folks use more equipment however i have been using this method for a long time and never had any problems.
Steps to go by:
1. Eliminate your patterns components of the material and interfacing. Many people will claim that you cutout you interfacing smaller than you interlining fabric manufacturer when you steam iron it, it won’t stick to your cloth or ironing board. That is up to you, you will know best how accurate you work.
2. Be sure before ironing the parts together the glue dotted side are facing a bad side of the fabric. This can be quite important part because if you iron the parts together and it’s the wrong sides it hard to eliminate the interfacing again, probably also be determined by the sort of interfacing and glue.
3. Place a cloth within the parts and make certain you iron is hot. I stumbled upon that steam doesn’t always work nicely so I use only a bit of steam setting on the iron. I use a cloth as being a fabbric iron can leave shiny marks on non woven interfacing fabric so you don’t want that.
4. When pressing the iron on the top of the cloth keep it for a few seconds about the same spot before moving onto another section. In addition, i do small sections at any given time no matter how small the parts are.
5. After ironing the various components let it rest to cool down to get a bit before using it to continue sewing your garment. I believe it is best to fuse every one of the interfacing parts before going ahead and start sewing the garment.